But does it also increase the DC power on the load side infinitely?
Parameter Sweep Analysis plots the appropriate curves sequentially.
Linear : The number of curves is equal to the difference between the start and end values divided by the increment step size.
Click OK to close the Sweep of Transient Analysis window.The current probe "IProbe" has been taken from the "Components" tab in the "probes" category and the dashed line separating generator and load side and the describing texts are taken from the "paintings" category.According to the theory the characteristic equation modeling this circuit can be represented as: Where is the damping factor and 0 the natural frequency (or resonant frequency).A marker can be placed on a dbs raffles city branch diagrams curve by the icon or using the "Set Marker on Graph" item in the "Insert" menu.R increases increases and the RLC circuit is driven towards an overdamped response since the value of in relation to 0 determines the behavior of the circuits response.A brief description of the parameter appears in the Description field and the present value of the parameter is displayed in the Present Value field.Sweeping a design variable.An equation block is inserted on the schematic area using the icon or using the "Insert" menu by activating the "Insert Equation" item.They are defined by: From the above equations you can see that as the value.Adding post-processing equations, the user can add computation formulas on a schematic in order to let the simulator perform.g.Complete the following steps to configure and run.
Additional Resources Entering Expressions in Analyses in Multisim spice Analysis Fundamentals Circuit Design Technical Library Download a 30-Day Evaluation of NI Multisim Join the NI Circuit Design Community.
Introduction, the behavior of a circuit is affected when certain parameters in specific components change.
Thus, increasing the load resistance would decrease the current and increase the voltage.
Analysis to sweep Select the analysis to sweep.
Click the Add button to move the variable to the right side under Selected variables for analysis, as shown below.Parameter Sweep Analysis to plot the transient step responses of the RLC circuit when.The parameter sweep box in the figure has been setup to sweep the DC simulation "DC1" linearily the parameter "Rload" which is the same we put into the "R" property of the load resistor from to in 101 steps, also another equation block has been.Octave : The number of curves is equal to the number of times the start value can be doubled before reaching the end value.The example guides the reader through the process of setting up a parameter sweep.Setting the load resistors resistance value to and adding the "DCpower" result to the table we obtain the following diagram.Original author: Stefan Jahn (2009).It obtains the maximum value of the computed DC power and then evaluates the value of load resistor value which causes the maximum power on the load side.Parameter Meaning Sweep Parameter Select a sweep parameter by choosing a parameter type ( Device or Model ) from the Sweep Parameter drop-down list, then enter information in the Device Type, Name, and Parameter fields. .This means there is no power consumed as well.